• Nedladdningar
  • Nyheter
  • Evenemang
  • SVENSKA
    AUSTRIANDEUTSCHENGLISHESPAñOLFRANçAISITALIANONEDERLANDSSUOMIVLAAMS
Eltako
  • Hem
  • Applikationer
    • säkerhet
    • inomhusklimat
    • Belysning
    • Solskydd
    • referenser
  • Produkter
    • Professional Smart Home
    • Professional Standard
    • Tillbehör
  • service
    • Nedladdningar
    • Evenemang
    • Eltako-Mobilen
    • frågor och svar
    • Smart hemblogg
  • Företag
    • Partners och allianser
    • Hållbarhet
    • Social Media
    • Kontakt
    • Historia

More results...

Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors
product
page
post
blog

Snabb hjälp - våra servicenummer

SVERIGE (NORD/MELLAN):
Säljare Patrick Savinainen
070 9596906 patrick@eltako.com


SVERIGE (ÖST):
Säljare Dan Koril
070 3201102 dan@eltako.com


SVERIGE (SYD):
Säljare Magnus Ellemark
070 170 21 30 magnus@eltako.com


SVERIGE (VÄST):
Säljare Glenn Johansson
073 5815692 glenn@eltako.com


SVERIGE (STOCKHOLM): Säljare Niklas Lundell 070 4875003 niklas@eltako.com


Alla Kontakter
Hem / Professional Standard / Universella tryckdimrar, effektutökare, 1-10 V styrenhet och universal vriddimmer / EUD12F
EUD12F

EUD12F

Universal dimmer switch for mains disconnection switching, 300W

Universal dimming switch. Power MOSFET up to 300W. Automatic lamp detection. Standby loss 0.1 watt only. With adjustable minimum brightness and dimming speed. With switching operation for children’s rooms and snooze function. Modular device for DIN EN 60715 TH35 rail mounting. 1 module = 18mm wide, 58mm deep. Universal dimmer switch for lamps up to 300W, depending on ventilation conditions, dimmable 230V LED lamps and dimmable energy saving lamps (ESL) are also dependent on the lamp electronics. Zero passage switching with soft start and soft OFF to protect lamps. Supply voltage and switching voltage 230V. Short-time control commands switch on/off, permanent control varies the brightness to the maximum level. An interruption of control changes the direction of dimming. The setting of the brightness level is stored after switching off. In case of a power failure the switching position and the brightness level are stored. If applicable the dimmer will be switched on at the stored brightness level after the supply voltage is recovered. Automatic electronic overload protection and over-temperature switch-off. With integrated switching-off relay for the mains disconnection of switched circuits. The control pushbutton(s) of the room are connected via low voltage control wires to the terminals T1 and T2 of the EUD12F (field-free internal DC voltage). The permanent power supply must be connected directly to a phase conductor ahead of the mains disconnection relay FR12-230V. Due to this, the complete function remains but the leads to the lamps is disconnected by means of the switching-off relay. A glow lamp current is not permitted. The minimum brightness level (completely dimmed down) can be adjusted with the upper ­rotary switch %lamp, e.g. for dimmable energy saving lamps. You can dim all lamp types in automatic mode. Use the lower dimming speed rotary switch to set the dimming speed in seven steps in automatic mode. +ESL is a convenience setting for energy saving lamps which must be switched on at high voltage for design reasons so that they can also be switched back on cold in dimmed state. -ESL is a convenience setting for energy saving lamps which cannot be switched back on in dimmed state for design reasons. This is why memory is switched off in this position. No inductive (wound) transformers may be used in +ESL and -ESL settings. In addition the maximum number of dimmable energy saving lamps may be lower than in automatic mode for design reasons. With special switching operation for children’s rooms: If the light is switched on by holding down the pushbutton, it starts at the lowest brightness level after approx. 1 second and dims up slowly as long as the pushbutton is held down without modifying the last stored brightness level. Snooze function: With a double impulse the lighting is dimmed down from the current dimming position to the minimum brightness level and switched off. The current dimming position as well as the adjustable minimum brightness level determine the dimming time (max. = 60 minutes) which can be reduced as required. It can be switched off at any time by short-time control commands during the lighting is dimmed down. Holding down the pushbutton during the dimming down process dims up and stops the snooze function. Mixing of L loads (inductive loads, e.g. wound transformers) and C loads (capacitive loads, e.g. electronic transformers) is not permitted. R loads (ohmic loads, e.g. 230V incandescent lamps and halogen lamps) may be added anytime. Mixing of L loads and C loads is possible with the dimmer switch EUD12D in connection with capacity enhancer LUD12.Teilungseinheit. Universal-Dimmschalter für Lampen bis 300W, abhängig von den Lüftungsverhältnissen. Dimmbare Energiesparlampen und dimmbare 230V-LED-Lampen zusätzlich abhängig von der Lampenelektronik. Schaltung im Nulldurchgang mit Soft-Ein und Soft-Aus zur Lampenschonung. Kurze Steuerbefehle schalten ein/aus, permanente Ansteuerung verändert die Helligkeit bis zu dem maximalen Wert. Eine Unterbrechung der Ansteuerung ändert die Dimmrichtung. Die eingestellte Helligkeitsstufe bleibt beim Ausschalten gespeichert. Bei einem Stromausfall werden die Schaltstellung und die Helligkeitsstufe gespeichert und wird gegebenenfalls bei Wiederkehr der Versorgungsspannung eingeschaltet. Automatische elektronische Überlastsicherung und Übertemperatur-Abschaltung. Mit integriertem Abschaltrelais zur Feldfreischaltung des geschalteten Stromkreises.

Art.-Nr.: 21100830 86.40€/St. *

* Recommended retail price plus VAT.

Data sheet
EUD12F
EUD12F

Andra tittade också:

IFE12-20.13

Impulse switch with bistable relay 10A/250V AC

IFE12-20.13

Data sheet
BPD55-D62

Blisterpack dimming

BPD55-D62

Datasheet
WSZ110CEE-16A-MID

Mobile single-phase energy meter with MID

WSZ110CEE-16A-MID

Data sheet Bruksanvisning WSZ110CEE-16A-MID
IFE12-10TS

Impulse switch with monostable relay 10A/250V AC

IFE12-10TS

Data sheet
Nedladdning eller online

Beställ den aktuella produktkatalogen 2023 nu!

Hög upplösning 31.2MB Låg upplösning 14.9MB
Hitta en systempartner
Support
  • Företag
    • Partners och allianser
    • Hållbarhet
    • Social Media
    • Kontakt
    • Historia
  • Applikationer
    • Säkerhet
    • inomhusklimat
    • Belysning
    • Solskydd
    • referenser
  • Produkter
    • Professional Smart Home
    • Professional Standard
    • Tillbehör
  • service
    • Nedladdningar
    • Evenemang
    • Eltako-Mobilen
    • frågor och svar
    • Smart hemblogg
© Copyright 2023 Eltako GmbH
  • frågor och svar
  • CoC
  • Leveransvillkor
  • Ansvarig
  • Dataskyddsinformation för kunder och partners

Newsletter abonnieren