Wireless 4-way pushbutton in E-Design65 pure white glossy, without wire. With double rocker
Wireless 4-way pushbutton for single mounting 84x84x16mm or mounting into the E-Design65 switching system. Silent and with battery (lifetime 2-5 years). With double rocker. Smart Home sensor. The scope of supply comprises a mounting base, an attachment frame with snapped-on electronics, a frame R1E, a rocker and a double rocker. Wireless pushbuttons with one rocker can transmit two evaluable signals: press rocker up and press rocker down. Wireless pushbuttons with double rocker can transmit four evaluable signals: press two rockers up or down. The mounting base can be screwed onto a flat surface or glued to the wall, on glass or on furniture using the enclosed adhesive foil. Use the sleeves in the 55mm socket box for screw mounting. Snap the large rocker so that the markings 0 and I on the back line up with the same markings on the wireless module. Installation only on a level surface: Screw on or glue mounting plate. Before screwing on, carefully remove the rockers and release the frame and attachment frame from the mounting plate. This can be done by pressing the top and bottom catches on the mounting plate outwards. Then screw on the mounting plate with the top and bottom catches snap on the frame and snap on the attachment frame including the electronics. The marking 0 must be at the top. Insert the enclosed battery and snap on the rocker. When you fit the rocker, the 0 mark on the rear must always be on top. The electronics integrated in the wireless pushbutton can be taught-in encrypted as described in the operating instructions in all encryptable actuators of the Series 61 and Series 71 as well as the FAM14.